Gas boiler proterm bear with a boiler. Boilers Protherm Bear KLZ (with built-in boiler). Advantages of heating units with built-in water storage

Protherm BearKLZ- this is a floor gas boiler, which is designed to heat water, which is located in the storage tank. A gas boiler with a power of 26 kW includes not only the function of heating water, but also other qualities. For example, there is a room heating function, automatic diagnostics, automatic control of the removal of combustion products, and many other positive functions.
Company gas boiler ProthermKLZ has many advantages over other boilers. Since in the company's boiler Proterm KLZ a special outlet for hot water circulation is built in, there is an expansion tank that can hold a sufficient amount of water, there are also 2 circulation pumps. Boilers Protherm Bear KLZ made of a material that protects the boiler from freezing. When making a boiler ProthermKLZ all safety measures were observed, so it was made according to all international standards. It is easy to control this equipment with the help of push-button control. A couple of clicks of special buttons and your gas boiler from the company Proterm KLZ will be able to work in the mode you need.
Another positive plus is that you can purchase this boiler in the color you need. After all, equipment is often selected for the interior of the room, and in this case, the boiler can be purchased in almost any color scheme. Basically, of course, it is white, a standard shade suitable for any interior.
Installing a gas boiler ProthermKLZ on the floor in any free corner. The boiler is 50.5 cm wide, 89.2 cm deep, and 138.5 cm high. In general, the boiler is not bulky and does not take up much space.
The gas boiler consumes approximately 0.13 kW of electrical energy. The voltage is standard 220 V.

An increasing number of consumers are striving for the organization of an autonomous heating system. The funds spent on the purchase and installation of heating equipment will soon pay off due to energy savings and the ability to independently regulate the power of the system.

The best way to heat private houses and apartments simultaneously with the possibility of obtaining hot water at any time and in the required quantity is to use a gas boiler equipped with a built-in boiler.

The device and principle of operation of the boiler with a built-in boiler

An integral part of such a heating unit is a tank designed for the accumulation of hot water. Its volume can vary from 10 to 100 liters. A secondary heat exchanger is built into the tank. The method of installing such a boiler largely depends on the volume of the boiler. Boilers with a capacity of up to 60 liters, as a rule, are wall mounted, more than 60 liters - floor.

These units may have an open or closed combustion chamber. In the first case, the heating equipment operates using traditional chimneys, in the second, combustion products are removed through coaxial chimneys.

Attention! The power range of boilers with a built-in boiler usually starts from 28 kW.

To get hot water, just open the tap. While hot water is consumed, the boiler heats up its new supply.

Advantages of heating units with built-in water storage

A gas boiler with a boiler is an ideal solution when using several water points (2-4) and provides the following advantages:

• A significant positive point is the possibility of heating water even during peak hours, when the pressure in the pipeline is very weak.

Attention! Double-circuit conventional boilers in this case may simply not be switched on for heating water in the DHW circuit.

• To start up the unit with a built-in hot water storage device, a separate device for water supply and heating systems is not required. It is enough to connect energy carriers to the boiler - gas and electricity (for the operation of automation), as well as water.
• The units are compact, so they do not require a lot of space for their placement. All component parts of the equipment are assembled in a single case.

Among the boiler equipment equipped with storage tanks, units of the Beretta and Protherm brands can be distinguished.

Boiler Beretta with built-in boiler

The Italian company Beretta is engaged in the production of heating equipment of all types. The products of this company belong to the economy class, but only high-quality materials are used for its manufacture.

Beretta Boiler 28 BAI is a wall mounted turbocharged boiler with a 60 liter stainless steel boiler. The power of the unit is 28 kW.

Features of the model that ensure its comfortable and safe operation:

• Automatic electric ignition, burner flame ionization control function.
• The modulating burner provides the possibility of a smooth change in power.
• Atmospheric burner made of stainless steel provides an easy transition from operation on main gas to liquefied gas.
• The boiler is equipped with a three-speed circulation pump with a deaerator.
• The heating equipment is equipped with two expansion tanks. One, with a volume of 8 liters, is installed in the heating circuit, the second has a volume of two liters and is installed in the DHW circuit.
• The boiler has two modes "Winter-Summer". In the "Winter" mode, the S.A.R.A. function is activated, which provides automatic control of the coolant temperature, while it is recommended to use a room temperature controller.
• The Safety Baby function (protection from burns) provides for a water temperature in the storage tank of approximately 43 0 С without the possibility of its regulation.

Advice! The Safety Baby function can only be activated via communication with the service department.

• Boiler anti-freeze protection system and pump anti-blocking system.
• External control devices can be connected to the equipment, which include a room thermostat, a programmer, an outdoor temperature sensor.

Attention! Connecting the programmer and the outdoor temperature sensor provides the function of weather-dependent regulation of the coolant temperature.

On the control panel there are: a thermomanometer, an operating mode switch, a heat carrier temperature regulator in the heating circuit, a water temperature regulator in the circuit responsible for supplying hot water, an indicator that reports on the state of the boiler.

The cost of this unit is approximately $ 1,500.

Design features of the boiler Protherm Bear 30 KLZ

The Protherm 30 KLZ model boiler is an excellent solution for those who, along with an efficient heating system, want to have an uninterrupted supply of hot water in the required quantity. The unit is equipped with a horizontal boiler with a capacity of 90 liters.

Design features of the Protherm 30 KLZ gas boiler:

• The storage tank contains a magnesium electrode that protects the tank from corrosion, and a built-in circulation pump.
• The power of the unit can be varied from 70 to 100% using a modulating burner.
• Combustion products can be discharged naturally or forcibly using a turbo attachment.
• The boiler has a floor version and can be adjusted in height to give stability to the unit.
• This equipment can be controlled by a thermostat and an outside temperature sensor.
• The boiler is equipped with two expansion tanks - 4 liters for the boiler and 10 liters for the heating circuit.

Attention! The Protherm 30 KLZ unit is used for heating and supplying hot water to private houses, apartments, offices, small industrial enterprises that have running water.

The approximate cost of the unit is $ 2,500.

Protherm is a leading manufacturer of heating and water heating technology. It is this company that manufactures some of the most reliable floor boilers. They are used to heat buildings and premises for various purposes - from private houses to commercial and industrial buildings. Floor boilers Protherm are characterized by:

It is impossible not to mention the quality service available throughout Russia.

Floor boilers Protherm are presented in two varieties - with steel and cast iron heat exchangers. The first are affordable and easy to install. Boilers with cast iron heat exchangers are more resistant to corrosion and thermal stress, and have an extended service life. Some models of cast-iron boilers are characterized by increased power, heating buildings and large areas.

Also, boilers are divided into single-circuit and double-circuit. Single-circuit models are simple, they are used to supply heat to heated rooms. Additional equipment is responsible for the production of hot water - indirect heating boilers and water heaters of all systems. Double-circuit models include a circuit for preparing hot water with a capacity sufficient for one or two draw points. In some models, storage tanks are provided for storing hot water - they are characterized by increased productivity, working with many consumers.

Protherm floor-standing boilers are equipped with numerous safety systems that monitor the presence of draft and flame. They also prevent overheating and freezing of equipment. For more convenient temperature control, room thermostats are offered for them - they independently maintain the set temperature regime. Most boilers need to be connected to the mains, but some models are non-volatile - they can work in buildings located far from gas mains. Separately, models are offered that are designed to heat large buildings - up to 1500 square meters. m. Also in the range of Protherm products there are boilers that run on several types of fuel - they are endowed with interchangeable burners to run on gas, fuel oil or diesel fuel.

You can buy floor-standing boilers from Protherm in the Teplodvor online store. Choose the right model, focusing on the heat output, the type of heat exchanger and the number of circuits - we will ensure prompt delivery in the Russian Federation, offer self-delivery, accompany the equipment with a factory warranty.